12-wheel multi-directional carriage
Top, bottom and side rollers support the beam vertically and laterally, so the leaf does not twist or rock.
Cantilever gate hardware that holds long leaves straight
Roller carriages, pull-rod systems and guides specified for 20 m+ aluminum leaves.
Inside the running gear
Precision bearings
Heavy-duty rollers and bearings keep rolling resistance low over repeated cycles.
Cast steel pull-rod system
Diagonal pull rods with cast steel heads control deformation on large gates.
Stainless steel pull-rod bracket
Keeps alignment across longer spans and resists corrosion.
Serviceable parts
Carriages, rollers and reinforcements can be adjusted or replaced one by one.
Matched to one of four beam profiles
Carriage size follows the beam. We match carriage, roller set and pull-rod layout to the 6005-T6 profile chosen for your gate length and height.
During installation the rear hanger wheel is set about 1.5 cm lower than the front cabinet support wheel, using the lever principle, so the leading edge does not drop.
Replacing hardware on an existing gate?
Send photos of your beam profile and carriage. We will tell you whether our parts fit.
Or email yifei@gmail.com